A resume that runs a few lines onto a second page looks unfinished. Most early- and mid-career candidates are better served by one strong page. Here is how to get there in the right order: layout first, content second, text size last.
Step 1: Tighten spacing before anything else
Large gaps between sections and generous line spacing are the cheapest space to reclaim. Reduce the gap between sections slightly and set line spacing to about 1.15–1.2.
Step 2: Narrow the margins a little
Margins of 0.5–0.75 inch (about 36–54 pt) are standard. Going below roughly 0.4 inch makes the page look crowded and can cause printing problems.
Step 3: Cut weak content
- Remove bullets that describe duties instead of results.
- Merge similar bullets.
- Drop jobs older than 10–15 years unless they are directly relevant.
- Shorten the summary to two or three lines.
- Remove “References available upon request”.
Step 4: Reduce text size last, and not too far
Body text below about 9.5–10 pt becomes hard to read on paper. Make small reductions only after spacing and content.
When two pages is fine
If you have more than roughly eight to ten years of relevant experience, many publications, or an academic CV, two pages is acceptable. Just make sure page two is at least half full.
Do it automatically
Our one-page resume maker does steps 1, 2 and 4 for you: it tightens spacing, then margins, then text size in small steps, and stops at 8.5 pt so the result stays readable. If it still can’t fit, it tells you to trim content.